Sequential Memory Programming
Spark
7-10
Sequential Memory Programming
Storing a memory does not, as you have seen, automatically clear the editor. This permits
building memories sequentially, using the channels and spots left in the editor to program
the next memory..
Example: Program a memory with channel 1. After storing the memory channel 1 is
retained in the editor. Now program the next memory by adding a few channels to the
current editor.
Keypresses Results/Comments
1. Select channel 1 and assign
intensity.
2. Press [=] [1] [STORE] to store
the memory.
Channel 1 remains in the editor.
3. Select channels 8
Æ
10.
4. Assign intensity values. When the wheel is moved the selected
channels are displayed in red.
5. Press [+1STORE]
Or
Press [=] [2] [STORE]
¾
¾
Note
The channels and spots that are selected in the editor (displayed in red) remain
selected after storing a memory using [+1STORE].