Memory Operations in the Editor
Spark
7-27
Exchanging memories switches the contents of 2 memories.
Example: Memory 5 is channel 5 @ 30. Memory 10 is channel 10 @ Full. when the
memories are exchanged Memory 5 is channel 10 @Full and memory 10 is channel 5 @
30.
Keypresses Results/Comments
1. Select memory 5.
2. Press [=]
Change to
Æ
appears in the command line.
3. Press [MEMORY] [10]
4. Press [STORE
The message
Memory 10 Stored
is displayed.
The contents of memory 5 and memory 10 are
exchanged.
Copying memories
You can copy the contents of a memory to a new memory.
Only the spots, channels, and their value are copied. This does not copy time assignments,
Parts, or Event Assignments.
To copy a memory including any time assignments, text, Loops, Parts, and Event
Assignments, perform the copy function in the Memory Operations menu.
Example: Copy memory 2 to memory 8.
Keypresses Results/Comments
1. Select memory 2.
2. Press [ENTER]
The channels and spots with their
intensity/parameter values appear as an editor
group.
3. Press [=]
4. Enter 8 on the numeric
keypad.
5. Press [STORE]
Only the contents of the memory (channels,
intensity assignments, scroller values, spots
and their parameter values) are copied.
¾
¾
Note
If the new memory number that you have selected is in use, the message Memory Exists is
generated. You can overwrite by pressing [STORE] again.