Using the Call Function
Spark
7-13
Merging selected output sources
Pressing the key associated with a specific output source calls the assignment to the editor.
More than one selection may be pressed in sequence. After collecting all the output, store
the result using the usual memory recording procedure
Use this function when you only want to Call some of the active playback devices.
Example: A three-color cyclorama wash is assigned to controllers 1 – 3. By combining the
3 colors at different levels, you create the desired color. . There are also active assignments
on A, and controllers 11 - 15. You want to record only the cyclorama wash, output from
controllers 1, 2, and 3, as memory 5.
Keypresses Results/Comments
1. Press [CALL]
2. Press the SK for controller 1 The output from controller 1 is turned into
an editor group.
3. Press the SK for controller 2. The output from controller 2 joins the editor
group.
4. Press the SK for controller 3. The output from controller 3 joins the editor
group.
5. Press [=] [5] or [MEMORY] [5]
6. Press [STORE]
The merged output from controllers 1, 2,
and 3 are stored as memory 5. The editor is
retained.
Editing after Call
All of the output merged in the editor is available for further editing. The editor is not
released after storing the memory.
Keypresses Results/Comments
1. Press [CALL]
2. Press [ENTER]
All active output is merged as an editor
group.
3. Select and modify chans/spots.
4. Press [=] [#]or [MEMORY] [#]
Set the system to memory record mode
and select a number.
5. Press [STORE]
The editor is not released.
To Next Page
Loading...
Need help?
General