Programming a Blackout Cue
Spark
7-9
Copying selected parameters from a memory
Example: Copy the gobo parameter from spot 10 in memory 1 to spot 4.
Keypresses Results/Comments
1. Select spot 4
2. Press the SK for gobo. The selected parameter is displayed in red.
3. Press [COPY]
Copy from
is written in the command line.
4. Select memory 1
5. Press 10 on the numeric
keypad to select spot 10.
6. Press [ENTER]
The selected parameter values are copied
from spot 10 in the selected memory to spot
4.
Programming a Blackout Cue
Blackout cues are created by recording a memory when the editor is empty. This can be
done in live or blind mode.
In the Memory List in the text column, blackout cues are automatically given the texzt
‘Blackout’.
When you examine blackout memories the message This Memory is a Blackout’ is
displayed.
Example: Record memory 8.5 as a blackout.
Keypresses Results/Comments
1. Press [RESET]
All spots and channels are cleared from
the editor and the editor is in idle mode.
2. Press [=] [ 8] [•] [5]
3. Press [STORE]