Programming Memories with Parts
Spark
15-3
Programming Memories with Parts
Spots and channels can be given part assignments during the initial programming of the
memory.
Only channels, scrollers, spots, and spot parameters that are selected (displayed in red) in
the editor can be given Part assignments.
Channels and spots that are in the editor when storing a memory and have no Part
assignment are assigned to Part 0.
Programming Parts with channels
Example: Program memory 1. Memory 1 contains channels 1 → 20. Channels 1
Æ
5 are
assigned to part 1. Assign part 1 fade times; time-in 3 seconds, wait 2 seconds. Channels 6
Æ
10 are assigned to part 2.
Keypresses Results/Comments
1. Select channels 1 → 5 and
assign intensity.
2. Press [PART] and enter 1
on the numeric keypad.
The intensity for channels 1 → 5 is displayed in
green – the color code for part 1.
3. Press [TIME] and enter 3
on the numeric keypad.
4. Press [WAIT] and enter 2
on the numeric keypad.
The Wait time is the amount of time part 1 will
wait before beginning its fade.
5. Select channels 6→ 10 and
assign intensity.
6. Press [PART] and enter 2
on the numeric keypad.
The intensity for channels 1 → 5 is displayed in
gray - the color code for part 2.
7. Press [TIME] and enter 8
on the numeric keypad.
8. Press [=] and enter 1 on the
numeric keypad.
9. Press [STORE]
The message
Memory 1 Stored
is displayed.