Loading the system configuration
It is recommended to load the configuration before loading a show file to avoid loading the
show file under Warning Difference (see Chapter 10 – Data Storing and Retrieval).
Keypresses Results/Comments
1. Press F6 Disk Operations
2. Insert the diskette with the
Configuration files.
3. Press F5 Load Config
The Config files are displayed.
4. Enter the file number on the
numeric keypad or use F2 and
F3 to select the file.
5. Press F5 Load S.T. Config
Load the selected file. The display returns to the
system configuration. The prompt
, Press F6 To
Store Changes!!!!
Is displayed.
6. Press F6 Store Configuration
Store the configuration that you have just
loaded. This is not always necessary and the
system will prompt you to store configuration if it
is needed.
To Next Page
Loading...
Need help?
General