EasyManuals Logo

Compulite Spark User Manual

Compulite Spark
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
Selecting Spots
Spark
6-5
Selecting a single spot
Keypresses Results/Comments
1. Press [SPOT]
Skip this step if the default number selection
is Spot.
2. Enter the desired spot
number on the keypad.
The parameter names of the selected spot/s
are displayed and they also appear on SK
controller display if [PARAM] is enabled.
To continue spot selection,
[
+]
and [] may be used to increment or decrement the active
spot number.
When a new spot is selected, the previous selection is now displayed in white to indicate
its presence in the editor. The newly selected, currently active spot number appears in red
and all of its parameters may be addressed.
Selecting multiple spots
There are several series of keystrokes to select one or more than one spot at a time. These
keystrokes may be combined in any way lending great versatility to spot selection.
[SPOT] [#] Select a single spot.
[SPOT #] [SPOT #] [SPOT #]... Select non-sequential spots.
[SPOT] [# → #] Select a range of spots.
Any permutations of spot selection may be used.
For example: [1
Æ
Æ
3] [SPOT 8] [SPOT 10] [SPOT 22
Æ
Æ
24]. These possibilities make
spot selection very flexible.
Recalling the last spot selection
For editing speed Spark offers a sequence that reselects the last group of spots that were
active in the editor.
Keypresses Results/Comments
1. Press [SPOT]
2. Press [•]
Spots that were selected previous to the last press on
[RESET] are selected and appear in red. They can now be
edited as usual.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compulite Spark and is the answer not in the manual?

Compulite Spark Specifications

General IconGeneral
BrandCompulite
ModelSpark
CategoryController
LanguageEnglish