Dividing a Memory into Parts
Spark
15-5
Programming Parts with selected parameters
Specific spot parameters can be assigned Parts. Only parameters appearing in light or dark
red can be assigned parts.
Example: Assign parameter 6 of spots 1 - 5 to part 1.
Keypresses Results/Comments
1. Select spots 1
Æ
5.
2. Select parameter 6 and
assign a value.
3. Press [PART] and enter 1 on
the numeric keypad.
Assign the selected parameter to part 1. A
green dash is displayed next to the selected
parameters.
4. Press [TIME] and enter 3 on
the numeric keypad.
Assign a fade of 3 counts to the selected
parameter in part 1.
5. Press [WAIT] and enter 2 on
the numeric keypad.
Assign a wait time: the amount of time part 1
will wait before beginning its fade.
6. Press [=] and enter 1 on the
numeric keypad.
7. Press [STORE]
The message
Memory 1 Stored
is displayed.
Dividing a Memory into Parts
Memories can be modified as Part Qs after they have been stored. This option works like
Basic Memory Modification and may be done live or in Blind mode.
Keypresses Results/Comments
1. Select memory 1
2. Select channels 1
Æ
5. The channels and spots are displayed in dark
blue.
3. Press [PART] and enter 1 on
the numeric keypad.
The intensity assignments of the selected
channels are displayed in green.
4. Press [TIME] and enter 3 on
the numeric keypad.
5. Press [WAIT] and enter 2 on
the numeric keypad.
6. Select channel 4
7. Press [PART] and enter 2 on
the numeric keypad.
The intensity assignment of the selected
channel is displayed in gray.
8. Press [WAIT] and enter 8 on
the numeric keypad.
9. Press [STORE]
Memory 1 is stored with the part assignments.