Stage Scrlr Provide a special display area for scroller information. The basic channel
display will no longer show frame information, but scroller channels will
still be marked with an 's'. Under the channel display, the special scroller
display shows the scroller channel number, the dimmer intensity (if any),
and the frame status.
Assign channels Channels used in memories are displayed in sequential order. This option
also influences the display when selecting channels. Example: Assume that
you have not programmed any memories yet. Select channels 1, 5, 10, 15. If
you have chosen the assign channels option, that is how they will appear on
the screen. In the default format the display would look like this:
1 5 10 15.
Jump display The display automatically jumps to the page where the selected channel or
spot appears.
SQZ (squeeze)
display
This option is available only if the Stage Scrlr option is active and the
scrollers are displayed separately. This provides more lines for displaying
channels.
SQZ spots Applies to display format 5 only. Choosing this option limits the channels to
10 channels a line.
Auto display When the active display format is just channels (display formats 0 and 1) the
display jumps to the spot display when spots are selected. When the active
display format is just spots (2, 3, and 8), the display jumps to the channel
display when channels are selected. From display formats 6 and 7 it jumps to
according to the selection.
The Stage Display
The display format for both channels and spots are formats 4 and 5.
Channels
The channel number, intensity, and frame number (if the channel number also serves a
scroller) are shown. Channel displays are display formats 0, 1, 4, and 5.
Spots
Spot displays are display formats 2, 3, 4, 5, and 8. The spot display depends on the number
and size of spots in the system configuration.
Each spot is shown as a vertical column and all spot parameters are displayed in the
column. The parameter numbers are displayed at the left side of the column. Parameter
names are displayed when a spot is selected.
The color of the parameter value displayed depends on the origin of the data; whether it
derives from A/B playback crossfaders, a controller, the editor, tracking or from a library.
Spot Parameters
X and Y (pan and tilt) display the coordinates of the spot's mirror or a yoke’s position
coordinates.
Dim is the level of the unit's dimmer.