Operating Macros
Spark
18-10
Operate Macros 21 - 40
Keypresses Results/Comments
1. Press [MACRO]
Pressing this key displays the Macros.
You can skip this step if the SK default
mode is Macro unless you want to view
the Macro List.
2. Press and hold [SHIFT] When SHIFT is pressed the display
shows
21 – 40
under the Mode on the
controller display.
3. Press an SK to operate a Macro
To operate Macro 26 press [SK
6], Macro 32 [SK 12], etc.
Operating Macros using the numeric keypad
When you select a Macro for operation, it is isolated in a window in the middle of the
screen and the command line displays Press F6 for start Macro! in red. The Macro
window closes automatically after 10 seconds. As long as the message is displayed in the
command line you can press [F6] to operate the Macro. If you press any other key the
Macro operation is aborted.
Keypresses Results/Comments
1. Press [F6]
The Macro list is displayed. Page this
list using [PAGE UP] and [PAGE DN].
2. Enter the Macro number on the
numeric keypad.
The Macro is displayed in a window for
10 seconds. The command line reads
Press F6 for start Macro!
3. Press [F6]
The Macro is triggered.