Playback with SMPTE
When the SMPTE generator starts at the time code 00:00:00.0 playback begins from Event
1. If the SMPTE generator has advanced beyond 00:00:00.0 the first Events triggered is the
Event whose SMPTE assignment is higher than the present running time.
Events are played back in ascending numerical sequence. If an Event has a lower SMPTE
assignment than the Event before it, the system will skip over that particular Event.
Keypresses Results/Comments
1. Press SMPTE
Select the SMPTE function. The function keys are
displayed in the command line area.
2. Press F1 Playback
A small yellow window opens at the top of the display
screen showing the event number and the SMPTE
time code.
3. Start the SMPTE
generator
Each Event is triggered when its SMPTE time code is
reached.
Exiting SMPTE playback
Keypresses Results/Comments
1. Press SMPTE
Select the SMPTE function. The function keys are
displayed in the command line area.
2. Press F3 Off
The SMPTE display at the top of the screen
disappears..
To Next Page
Loading...
Need help?
General