The Mix Output Menu
Spark
21-3
Spark’s default Device List is divided into three types of devices:
• DMX - DMX devices are operator programmable. You can define devices in the
Define Device (under F2 Select Device) option in this menu.
DMX devices appear in the upper section of the Device List.
• L-MIX devices are Coemar NAT 2500 and NAT 1200. These moving lights work
under DMX protocol. Access to the device definition is limited to Invert, Jump on x-
fade, include/exclude parameters from libraries, include parameters in CL1 or CL2,
define parameters’ home values, and wheel set ups.
L-Mix devices appear in the middle section of the Device List.
• High End/ S-Mix are devices that use proprietary protocols. Access to the device
definition is limited to Invert, Jump on x-fade, include/exclude from libraries, include
parameters in CL1 or CL2, define parameters’ home values, and wheel set ups.
These devices appear in the lower section of the Device List.
The definition table
The device’s full name and short name, and output length head the Definition Table, on
the right side of the screen.The device’s parameter names, parameter control channel, and
other parameter configurations are displayed in the Definition Table.
The Definition Table displays information on the spot highlighted in the Device List.
Other information
Under the Assignment Table, the overall spot configuration (as defined in Service
Tools/Config Sys) is displayed.
The libraries’ parameters reference is also displayed.