© 06/2006 8191-001
3/6
TCD 2015
Speed control
W 05-07-01
6
z Insert dial gauge in adapter (1).
1
© 45897-0
z Insert adapter with dial gauge under pre-tension in
the base plate (1).
z Fix dial gauge in adapter.
z Turn the dial until the pointer points to "0".
1
© 45898-0
z Insert and press in adapter with dial gauge into the
connection housing until it stops.
z Note measured value.
z Make 120° orientation marks on the vibration damp-
er.
z Turn the crankshaft to the next 120° mark in direction
of rotation.
z Note measured value.
z Select lowest measured value of 3 measurements,
dimension (a).
The stylus of the dial gauge must touch the
level flywheel surface.
Attention!
Remove adapter and dial gauge before
turning the crankshaft.
© 45899-0
To Next Page
Loading...
