C
HAPTER
29
| Rate Limit Commands
– 772 –
actually be 100 Kbps, or 1/5 of the 500 Kbps limit set by the storm
control command. It is therefore not advisable to use both of these
commands on the same interface.
◆ See the description of effective rate limiting in the Command Usage
under "Rate Limiting" on page 227.
N
OTE
:
Due to a chip limitation, the switch supports only one limit for both
ingress rate limiting and storm control (including broadcast unknown
unicast, multicast, and broadcast storms).
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 64
Console(config-if)#
RELATED COMMAND
show interfaces switchport (742)
To Next Page
Loading...
