When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
expansion card’s firmware.
Ê Press the displayed key combination.
Ê Modify the expansion card firmware options as desired.
Ê Save your changes and exit the firmware.
I The expansion card’s option ROM can now be disabled in the system
board BIOS.
Exception: If the expansion card controls a permanent boot device, the
card’s Option ROM has to remain enabled.
5.2.5 Verifying and configuring the backup software
solution
I This task only applies to the Japanese market.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
This is the case for the following backup software solutions:
– Netvault for Windows
– ARCServe
– BackupExec
I Procedures may differ depending on the backup software. For details,
refer to the dedicated documentation provided separately.
Further information on suitable backup software solutions and related
documentation is available to Fujitsu service partners from the Fujitsu
Extranet web pages.
To Next Page
Loading...
Need help?
General