9.6.7.5 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Installing the SAS expander board" on page 309 (if applicable)
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê If applicable, update the firmware of the RAID controller that has been
connected to the BBU as described in section "Updating RAID controller
firmware" on page 137.
Ê "Enabling SVOM boot watchdog functionality" on page 146
9.6.8 Replacing a TFM module
V CAUTION!
For further safety information, please refer to chapter "Important
information" on page 45.
9.6.8.1 Preliminary steps
Ê "Disabling SVOM boot watchdog functionality" on page 127
Ê "Shutting down the server" on page 62
Ê "Disconnecting the server from the mains" on page 63
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Upgrade and Repair Unit
(URU)
Average task duration:
10 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
Need help?
General