Ê Secure the HDD bay top cover to the chassis with five M3 x 4.5 mm screws
(see blue arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw (see orange arrow).
7.3.10.7 Cabling the SAS backplanes
Ê Connect SAS and power cables to the 3.5-inch SAS backplanes as
described in section "8x 3.5-inch HDD SAS backplane cabling" on page 245.
7.3.10.8 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê Install HDD modules or HDD dummy modules into the additional HDD slots
as described in sections "Installing a 3.5-inch HDD module" on page 256
and "Installing a 3.5-inch HDD dummy module" on page 261.
I For detailed information on HDD mounting order, refer to section "3.5-
inch HDD configurations" on page 241.
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task: "Resuming BitLocker functionality" on page 152
To Next Page
Loading...
Need help?
General