Ê "Locating the defective server" on page 57
Ê "Shutting down the server" on page 62
Ê "Disconnecting the server from the mains" on page 63
Ê Remove all external cables from the expansion card to be replaced.
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section "Opening the server" on
page 68.
Ê "Removing the system air duct" on page 81
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section "Onboard indicators and controls" on
page 779.
9.2.3.2 Removing an expansion card
Ê If applicable, remove SFP+ transceiver modules from the expansion card to
be removed.
Ê Remove the defective expansion card as described in section "Removing
expansion cards" on page 357.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Preparing the expansion card" on
page 350.
9.2.3.3 Installing an expansion card
Ê If applicable, install a slot bracket on the new expansion card as described
in section "Preparing the expansion card" on page 350.
Ê Install the new expansion card as described in section "Installing expansion
cards" on page 349.
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card.
To Next Page
Loading...
Need help?
General