12.5.3.3 Removing the slimline ODD from the Multibay box
Ê Remove the defective slimline ODD from the Multibay box as described in
section "Removing the slimline ODD from the Multibay box" on page 563.
12.5.3.4 Removing the LSD module from the Multibay box
Ê Remove the defective LSD module from the Multibay box as described in
section "Removing the LSD module from the Multibay box" on page 565.
12.5.3.5 Installing the slimline ODD into the Multibay box
Ê Install the new the slimline ODD into the Multibay box as described in section
"Installing the slimline ODD into the Multibay box" on page 569.
12.5.3.6 Installing the LSD module into the Multibay box
Ê Install the new LSD module into the Multibay box as described in section
"Installing the LSD module into the Multibay box" on page 555.
12.5.3.7 Installing the Multibay box
Ê Reinstall the Multibay box as described in section "Installing the Multibay
box" on page 557.
12.5.3.8 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 139.
To Next Page
Loading...
Need help?
General