14.6.2 Removing the system board
Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section "Removing processor heat sinks" on page 523
I Leave the processor on the defective board for now.
– Memory modules: refer to section "Removing memory modules" on
page 479
I Ensure to take note of the memory modules’ mounting positions
for reassembly.
– Expansion cards: refer to the section "Removing expansion cards" on
page 357
I Ensure to take note of the controllers’ mounting positions and
cable connections for reassembly.
– UFM board: refer to section "Removing the UFM board" on page 653
I Remove the UFM spacer from the defective system board and
fasten it to the UFM board with the UFM screw.
– Onboard SAS enabling key: refer to section "Replacing the onboard SAS
enabling key" on page 678
– iRMC microSD card: refer to section "Removing the iRMC microSD card"
on page 681
To Next Page
Loading...
Need help?
General