GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 3 - System Setup 3 - 95
3-10-8-2 DICOM Server IP Address Setting on the Scanner - Software Version v3.x (cont’d)
7.) Select the IP-Address down-arrow to choose the Worklist Server from the pull-down menu.
NOTE: It is not possible to change the setting in the IP-Address field by editing it. See description
below, starting with step 8, to change the setting.
8.) Follow the steps below to change the IP-Address settings:
a.) From the Ip-Address pull-down menu, select <Modify> to display the IPs dialog.
b.) Select the server you want to modify from the IPs dialog and then select Modify.
Figure 3-100 DICOM Server’s Properties dialog
Figure 3-101 Select <Modify>
Figure 3-102 Select the unit to modify
Modify
Select server
To Next Page
Loading...
