Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
11.8 AT+CGEQMIN
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 297 of 513
64...568 (value needs to be divisible by 8 without remainder)
576...8640 (value needs to be divisible by 64 without remainder)
This parameter indicates whether the UMTS bearer shall provide in-sequence SDU delivery or not.
[0] no
1yes
This parameter indicates the maximum allowed SDU size in octets.
[0]
10...1500 (value needs to be divisible by 10 without remainder)
1502
1510
1520
This parameter indicates the target value for the fraction of SDUs lost or detected as erroneous. SDU error ratio
is defined only for conforming traffic. The value is specified as "mEe". As an example a target SDU error ratio
of 5*10
-3
would be specified as "5E3" (e.g. AT+CGEQMIN=...,"5E3",...).
[“0E0“] subscribed value
“1E2“
“7E3“
“1E3“
“1E4“
“1E5“
“1E6“
“1E1“
This parameter indicates the target value for the undetected bit error ratio in the delivered SDUs. If no error
detection is requested, Residual bit error ratio indicates the bit error ratio in the delivered SDUs. The value is
specified as "mEe". As an example a target residual bit error ratio of 5*10
-3
would be specified as "5E3" (e.g.
AT+CGEQMIN=...,"5E3",...).
[“0E0“] subscribed value
“5E2“
“1E2“
“5E3“
“4E3“
“1E3“
“1E4“
“1E5“
“1E6“
“6E8“
<Delivery order>
(num)(NV)
<Maximum SDU size>
(num)(NV)
<SDU error ratio>
(str)(NV)
<Residual bit error ratio>
(str)(NV)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English