Cinterion
®
EHS6 AT Command Set
15.2 AT+CPBR
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 382 of 513
Phone number in format specified by <type>, it may be an empty string.
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with ATD><mem><n> is, depending
on the network, not always possible (refer to 3GPP TS 24.008 [40] subclause 10.5.4.7 for details). See also
<type> of AT+CPBW.
Possible values are:
145 Dialing string <number> includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string <number> has been saved as ASCII string and includes non-
digit characters other than "*", "#", "+" or "p". Note that phonebook entries
saved with this type cannot be dialed.
255 Dialing string <number> is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
128...255 Other values, refer to 3GPP TS 24.008 [40], subclause 10.5.4.7 for details.
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter <tlength>.
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.7, Supported character sets.
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
Maximum length of phone number for "normal" locations.
Maximum length of <text> assigned to the telephone number. The value indicated by the test command is
given in octets. If <text> is given as GSM characters each character corresponds to one octet. If the <text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to 3GPP TS 11.11 [17], 3GPP TS 31.101 [18], 3GPP TS 31.102 [19], Annex B. In the
worst case the number of UCS2 characters is at least one less than half the number of GSM characters.
Example
<number>
(str)
<type>
(num)
<text>
(str)(+CSCS)
<maxloc>
(num)
<nlength>
(num)
<tlength>
(num)
AT+CPBR=?
First run the AT+CPBR test command to find out the
maximum range of entries stored in the active
phonebook.
+CPBR:(1-100),20,17
EHS6 returns the supported values, where 100 is the
supported range of location numbers, 20 is the
length of the phone number and 17 is the maximum
length of the associated text.
To Next Page
Loading...
Need help?
General
