Cinterion
®
EHS6 AT Command Set
2.8 AT+CFUN
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 40 of 513
6 This mode was implemented in EHS6 Release 1 for activating the USAT inter-
face. As of EHS6 Release 2 the mode is deprecated and no longer effective.
USAT can now be used in Automatic or Explicit Response Mode depending on
AT^SSTA settings.
7 Reserved for future use.
8 Reserved for future use.
Parameter <rst> applies only to <fun> 1 and 4.
[0] ME switches to <fun> level without reset.
1 ME resets and restarts to full functionality level or Airplane mode, depending
on given <fun> value. "^SYSSTART" URC indicates that the ME is ready to
operate.
Note: Autobaud mode (see AT+IPR) requires an "AT" or "at" string be given
after restart. This enables the ME to detect the bit rate set in the TE. After
detecting the bit rate the ME will send the "^SYSSTART" URC.
1 ME is switched on
2 Invalid mode
4 Airplane mode
0 Deprecated. See above <fun> value 6.
6 Deprecated. See above <fun> value 6.
7 Reserved for future use.
8 Reserved for future use.
<rst>
(num)
<power_mode>
(num)
<STK_mode>
(num)
To Next Page
Loading...
Need help?
General
