EasyManuals Logo

Gemalto Cinterion EHS6 User Manual

Gemalto Cinterion EHS6
513 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #444 background imageLoading...
Page #444 background image
Cinterion
®
EHS6 AT Command Set
18.7 AT^SRVCFG
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 444 of 513
Wifi assistance data
This parameter can be used to control Wifi assistance data to be calculated for positioning. Only all the manda-
tory configurations for wifi were set, this parameter could be set to "1", at meantime configurations for Wifi would
be locked. Note that this parameter would be reset to "0" automaically, after the GPS entity is used.
0
(D)
Do not use Wifi assistance data for location requests.
1 Using Wifi assistance data for next location request. This setting will be auto-
matically reset to <CBLUrc>=0 after next uccessful location request.
The BSSID of the Wifi
This parameter indicates the MAC address of the Wifi router, e.g 00:50:56:C0:01. It is a mandatory configuration
for Wifi, and default as empty (""). Note that this parameter will be reset to "", after the Wifi entity has been used.
““
(D)
The The BSSID of the Wifi is not set
The SSID of the Wifi
This parameter represents the name of Wifi access point. The maximal length of the string is 32. Note that this
parameter will be reset to "", after the Wifi entity has been used.
““
(D)
The SSID of the Wifi is not set
The measured signal strength of the Wifi
This parameter denotes the received signal strength in dBm. Note that this parameter will be reset to "", after
the Wifi entity has been used.
-65535...0 A valid signal strength of the Wifi router
““
(D)
The signal strength of the Wifi router is not set
Notes
•The <CBLUrc> will be reset to "0" when any errors occur during the service.
<CBLGps> and <CBLWifi> will be automatically reset to "0" after next successful location request.
Only if mandatory configurations for gps/wifi are set, the corresponding mode can be set to 1. Configurations
cannot be modified while the corresponding mode is 1.
Example
Usage of "CBL":
<CBLWifi>
(num)(NV)
<CBLBssid>
(str)(NV)
<CBLSsid>
(str)(NV)
<CBLRssid>
(str)(NV)
AT+CSCS="UCS2"
Switch to UCS2 character set.
OK
AT^SRVCFG="CBL","key","a2f2j4l6kj34lo12ppbg
"
Set COMBAIN key.
OK
AT^SRVCFG="CBL","key"
Query COMBAIN key.
^SRVCFG: "a2f2j4l6kj34lo12ppbg"
OK
AT^SRVCFG="CBL","urc",1
Activate URC mode.
OK
AT^SRVCFG="CBL","urc"
Query URC mode.
^SRVCFG: "1"

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gemalto Cinterion EHS6 and is the answer not in the manual?

Gemalto Cinterion EHS6 Specifications

General IconGeneral
BrandGemalto
ModelCinterion EHS6
CategoryControl Unit
LanguageEnglish

Related product manuals