EasyManuals Logo

Gemalto Cinterion EHS6 User Manual

Gemalto Cinterion EHS6
513 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #511 background imageLoading...
Page #511 background image
Cinterion
®
EHS6 AT Command Set
21.7 Alphabetical List of AT Commands
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 511 of 513
AT^SGCOPS Operator Selection for GPRS-ONLY SIM Cards Section 8.11, page 181
AT^SGIO Get IO State of a Specified Pin Section 20.2, page 476
AT^SHUP Hang up call(s) indicating a specific 3GPP TS 24.008
release cause
Section 7.9, page 144
AT^SICI Internet Connection Information Section 10.2, page 231
AT^SICS Internet Connection Setup Profile Section 10.1, page 228
AT^SIND Extended Indicator Control Section 3.2, page 90
AT^SIPS Internet Profile Storage Section 10.3, page 234
AT^SISC Internet Service Close Section 10.7, page 249
AT^SISE Internet Service Error Report Section 10.13, page 261
AT^SISH Disconnect Remote Client Section 10.11, page 258
AT^SISI Internet Service Information Section 10.5, page 243
AT^SISO Internet Service Open Section 10.6, page 245
AT^SISR Internet Service Read Data Section 10.8, page 250
AT^SISS Internet Service Setup Profile Section 10.4, page 235
AT^SIST Enter Transparent Access Mode Section 10.10, page 256
AT^SISW Internet Service Write Data Section 10.9, page 253
AT^SISX Internet Service Execution Section 10.12, page 259
AT^SJAM Manage Java Application Section 17.1, page 410
AT^SJDL Java Download Section 17.2, page 413
AT^SJMSEC Java Midlet Security Section 17.3, page 415
AT^SJNET Set Dialup Network Access Parameters Section 17.4, page 418
AT^SJOTAP Over The Air Application Provisioning Section 17.5, page 420
AT^SJRA Run Java Application Section 17.6, page 423
AT^SLED LED Feature Section 19.5, page 457
AT^SMGL List Short Messages from preferred store without setting
status to REC READ
Section 12.19, page 350
AT^SMGR Read short message without setting status to REC READ Section 12.20, page 351
AT^SMONI Monitoring Serving Cell Section 8.12, page 182
AT^SMONP Monitoring Neighbour Cells Section 8.13, page 189
AT^SMSO Switch Off EHS6 Section 2.9, page 41
AT^SNFI Set microphone path parameters Section 16.6, page 399
AT^SNFM Set microphone audio path and power supply Section 16.7, page 400
AT^SNFO Set audio output (= loudspeaker path) parameter Section 16.8, page 401
AT^SNFS Select audio hardware set Section 16.9, page 402
AT^SNFTTY Signal TTY/CTM Audio Mode Capability Section 16.10, page 404
AT^SNMON Network Monitoring Section 8.14, page 194
AT^SPIC Display PIN counter Section 6.5, page 130
AT^SPIO GPIO Driver Open/Close Section 20.7, page 484
AT^SPOW Set UART Mode and SLEEP Mode on UART Section 2.13, page 80
AT^SRADC Configure and Read ADC Measurement Section 19.6, page 459
AT^SRTC Ring tone configuration Section 16.11, page 405
AT Command Description Section and Page

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gemalto Cinterion EHS6 and is the answer not in the manual?

Gemalto Cinterion EHS6 Specifications

General IconGeneral
BrandGemalto
ModelCinterion EHS6
CategoryControl Unit
LanguageEnglish

Related product manuals