Cinterion
®
EHS6 AT Command Set
21.7 Alphabetical List of AT Commands
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 512 of 513
AT^SRVCFG Service Configuration Settings Section 18.7, page 438
AT^SRVCTL Extra Service Control Section 18.8, page 446
AT^SSCNT Start and Stop Pulse Counter Section 20.5, page 479
AT^SSIO Set IO State of a Specified Pin Section 20.3, page 477
AT^SSPI Serial Protocol Interface Section 19.7, page 462
AT^SSTA Remote-SAT Interface Activation Section 14.1, page 356
AT^SWDAC PWM Signal Configuration for DAC Section 19.8, page 471
AT^SXCALLSTAT Set Reporting Call Status Section 7.17, page 154
AT^SXEONS Display EONS Names Section 8.4, page 171
AT^SXRAT Selection of Radio Access Technology Section 8.3, page 169
ATA Connect to Incoming Call Section 7.1, page 134
ATA Manual acceptance of a network request for PDP context
activation
Section 11.16, page 315
ATD Mobile originated call to specified number Section 7.2, page 135
ATD*99# Request Packet Domain Service Section 11.17, page 316
ATD><mem><n> Mobile originated call using specific memory and index
number
Section 7.3, page 137
ATD><n> Mobile originated call from active memory using index
number
Section 7.4, page 139
ATD><str> Mobile originated call from active memory using corre-
sponding field
Section 7.5, page 140
ATDL Redial last number used Section 7.6, page 141
ATE AT Command Echo Section 4.5, page 106
ATH Disconnect existing connection Section 7.7, page 142
ATI Display product identification information Section 5.1, page 113
ATL Set monitor speaker loudness Section 16.1, page 392
ATO Switch from command mode to data mode / PPP online
mode
Section 7.11, page 146
ATQ Result Code Presentation Mode Section 2.4, page 35
ATS0 Set number of rings before automatically answering a call Section 7.10, page 145
ATS10 Set disconnect delay after indicating the absence of data
carrier
Section 7.24, page 164
ATS3 Command Line Termination Section 18.2, page 425
ATS4 Response Formatting Section 18.3, page 426
ATS5 Command Line Editing Section 18.4, page 427
ATS6 Set pause before blind dialing Section 7.21, page 161
ATS7 Set number of seconds to wait for connection completion Section 7.22, page 162
ATS8 Comma Dial Pause Time Section 7.23, page 163
ATV Result code format mode Section 2.5, page 36
ATX CONNECT Result Code Format Section 2.6, page 37
ATZ Restore AT Command Settings from User Defined Profile Section 2.7, page 38
AT Command Description Section and Page
To Next Page
Loading...
Need help?
General
