Gemalto Cinterion EHS6 - Page 60

Cinterion
®
EHS6 AT Command Set 
2.12 AT^SCFG
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 60 of 513
^SCFG: "Radio/Mtpl", <PL_mode>, <PL_profile>, <rba>, <PL_limit>[, <PL_limit8psk>]
^SCFG: ["Radio/Mtpl", <PL_mode>, <PL_profile>, <rba>, <PL_limit>[, <PL_limit8psk>]]
^SCFG: ["Radio/Mtpl", <PL_mode>, <PL_profile>, <rba>, <PL_limit>[, <PL_limit8psk>]]
^SCFG: ["Radio/Mtpl",...]
In case of: <PL_mode>=3 and <PL_profile>, <rba>,<PL_limit>[,<PL_limit8psk>] only the enabled
profile is printed out
^SCFG: "Radio/Mtpl", <PL_mode>[, <PL_profile>]
OK
ERROR
+CME ERROR: <err>
Write Command
Radio output power reduction
AT^SCFG="Radio/OutputPowerReduction"[, <ropr>]
Response(s)
^SCFG: "Radio/OutputPowerReduction", <ropr>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure allocation of serial interfaces:
AT^SCFG="Serial/Interface/Allocation"[, <reqSerialIfcAlloc>]
Response(s)
^SCFG: "Serial/Ifc", <curSerialIfcAlloc>, <reqSerialIfcAlloc>
OK
ERROR
+CME ERROR: <err>
Write Command
USB Device Descriptor:
AT^SCFG="Serial/USB/DDD" [, <deviceDescr>, [<descrIndex>], [<langId>], <vendorId>,
<productId>, [<manufacturer>], [<product>], [<serialNo>]]
Response(s)
^SCFG: "Serial/USB/DDD" , <deviceDescr>, <descrIndex>, <langId>, <vendorId>, <productId>,
<manufacturer>, <product>, <serialNo>
OK
ERROR
+CME ERROR: <err>
Write Command
Configuration of TCP parameter 'InitialRetransmissionTimeout':
AT^SCFG="Tcp/IRT"[, <tcpIrt>]
Response(s)
^SCFG: "Tcp/IRT", <tcpIrt>
OK
ERROR
+CME ERROR: <err>
Write Command (Continued)
Instant Power Limitation for SAR Reduction and Thermal Mitigation
AT^SCFG="Radio/Mtpl"[, <PL_mode>[, <PL_profile>, <rba>, <PL_limit>[, <PL_limit8psk>]]]
Response(s)