Cinterion
®
EHS6 AT Command Set
2.12 AT^SCFG
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 77 of 513
Power Limitation
This parameter is used to set the power limit.
Parameter is global for the ME, non-volatile and will not be reset by AT&F.
Setting takes effect after next restart.
18...33 Power limit value in dBm for GSM low bands.
18...30 Power limit value in dBm for GSM high bands.
18...24 Power limit value in dBm for WCDMA bands.
Power Limitation 8 PSK
This parameter is used to set the power limit 8 PSK.
Parameter is global for the ME, non-volatile and will not be reset by AT&F.
Setting takes effect after next restart.
18...27 Power limit value in dBm only for GSM 8 PSK low bands.
18...26 Power limit value in dBm only for GSM 8 PSK high bands.
Examples
EXAMPLE 1
Usage of "URC/Ringline":
EXAMPLE 2
Usage of parameter <upwd> if no password was configured so far (password is empty):
EXAMPLE 3
The example shows how to read, configure, activate and deactivate output power limitation using the
AT^SCFG "Radio/Mtpl" subcommand. See parameters <PL_mode>, <PL_profile>, , <PL_limit>,
<PL_limit8psk>.
<PL_limit>
(str)
<PL_limit8psk>
(str)
AT+CSCS="GSM"
Switch to GSM character set.
OK
AT^SCFG?
Query all parameters.
...
^SCFG:"URC/Ringline","local"
URCs on this interface will be indicated by Ring line
associated to the interface (e.g. RING0 for ASC0).
...
OK
AT^SCFG="URC/Ringline","asc0"
^SCFG:"URC/Ringline","asc0"
URCs on this interface will be indicated by an acti-
vated RING0 no matter whether or not the ME-TE
link is reserved.
OK
AT^SCFG="URC/Ringline","off"
Disable any Ring line indication for URCs on this
interface.
^SCFG:"URC/Ringline","off"
OK
AT^SCFG="Userware/Autostart","","1"
Correct password specification
^SCFG: "Userware/Autostart","1"
OK
AT^SCFG="Userware/Autostart",,"1"
Correct password specification
^SCFG: "Userware/Autostart","1"
OK
To Next Page
Loading...
