3. Use the arrow buttons on the touchscreen to navigate the Pre-boot menu.
4. Touch the OK button to select a menu item.
Open the Pre-boot menu from an LCD control panel
1.
Press the Cancel button when you see the 1/8 under the HP logo.
2. Use the arrow buttons on the control panel to navigate the Pre-boot menu.
3. Press the OK button to select a menu item.
Cold reset using the Pre-boot menu from a touchscreen control panel
CAUTION: This procedure resets all printer congurations and settings to factory defaults (customer
congurations and settings are lost).
1. Touch in the middle of the control-panel display when you see the 1/8 under the HP logo.
Figure 2-3 Open the Pre-boot menu
2. Use the down arrow button to highlight the +3:Administrator item, and then touch the OK button.
3. Use the down arrow button to highlight the +8:Startup Options item, and then touch the OK button.
4. Use the down arrow button to highlight the 2 Cold Reset item, and then touch the OK button to select
it.
5. Touch the Home button to return to the main Pre-boot menu and highlight the 1:Continue item, and then
touch the OK button.
NOTE: The printer will initialize.
Cold reset using the Pre-boot menu from an LCD control panel
CAUTION: This procedure resets all printer congurations and settings to factory defaults (customer
congurations and settings are lost).
1.
Press the Cancel button when you see the 1/8 under the HP logo.
2. Use the button to highlight the +3:Administrator item, and then press the OK button.
3. Use the button to highlight the +8:Startup Options item, and then press the OK button.
90 Chapter 2 Solve problems ENWW
To Next Page
Loading...