HP LaserJet Enterprise M552 - USB flash drive (control-panel menu)

USB ash drive (control-panel menu)
NOTE: USB ash drives that are not using a FAT32 format, or do not have a CD formatted partition, might
not be recognized by the printer. If the printer does not recognize a USB ash drive, try using a dierent USB
ash drive.
TIP: The USB port on the printer must be enabled. If it is disabled, use the Enable Retrieve from USB item in
the General Settings menu to enable it.
USB ash drive rmware update from a touchscreen control panel
1. Copy the .bdl le to a portable USB ash drive.
2. Turn the printer on, and then wait until it reaches the Ready state.
3. From the Home screen on the printer control panel, scroll to and touch the Device Maintenance button.
4. Touch the USB Firmware Upgrade button.
5. Insert the portable USB storage device with the .bdl le on it into the USB port on the front of the
printer.
6. Touch the .bdl le, and then touch the Upgrade button.
TIP: If there is more than one .bdl le on the storage device, make sure to select the correct le for this
printer.
7. Select one of the following options:
●
Upgrade
NOTE: The upgrade process can take 10 minutes or longer to complete.
●
Re-install
●
Downgrade
8. When the upgrade is complete, the printer will initialize to the Ready state. Print a conguration page
and verify that the upgrade rmware version was installed.
USB ash drive rmware update from an LCD control panel
1. From the Home screen on the printer control panel, use the down arrow button to scroll to Device
Maintenance, and then press the OK button.
2. Open the following menus:
●
USB Firmware Upgrade
3. Insert the portable USB storage device with the .bdl le on it into the USB port on the printer.
4. If necessary, use the down arrow button to scroll to the appropriate .bdl le, and then press the OK
button to select.
5. Use the down arrow button to scroll to Upgrade, and then press the OK button to start the rmware
upgrade.
NOTE: If the rmware in the .bdl le on the portable USB storage device matches the installed
rmware on the printer, Upgrade is replaced by Re-Install.
ENWW Firmware upgrades 491