50.8X.YZ
Description
Low fuser temperature 2
Recommended action
1. Remove and reinstall the fuser. Make sure that it is seated correctly.
2. Make sure that there is no residual paper in the fuser.
3. Check the connector (J50) between the fuser and the printer. If it is damaged, replace the fuser drive
assembly or fuser.
4. Reconnect the connector (J2603) on the fuser control PCA and connector (J116) on the DC controller PCA
5. If the issue persists, replace the fuser.
6. If error still remains, replace the Fuser PCA assembly. Fuser Power Supply assembly Part number:
RM2-7125-000CN.
7. If error still remains, replace the Fuser Power Supply assembly Part number: RM2-7125-000CN.
50.9X.YZ
Description
High fuser temperature 2
Recommended action
1. Remove and reinstall the fuser. Make sure that it is seated correctly.
2. Make sure that there is no residual paper in the fuser.
3. Check the paper type setting in the printer control panel menus and in the print driver. Make sure that
the settings match and are correct for the type of media being used.
4. Check the connector (J50) between the fuser and printer. If the connector is damaged, replace the
connector assembly or the Fuser.
5. If the issue persists, replace the fuser.
6. If error still remains, replace the Fuser PCA assembly.
50.AX.YZ
Description
Low fuser temperature 3
Recommended action
1. Remove and reinstall the fuser. Make sure that it is seated correctly.
2. Make sure that there is no residual paper in the fuser.
3. Check the connector (J50) between the fuser and the printer. If it is damaged, replace the fuser drive
assembly or fuser.
ENWW Tools for troubleshooting 335
To Next Page
Loading...