9. Test the registration assembly and check connectors J118 and J16 on the DC Controller.
10. If any test shows defective part replace the appropriate assembly.
13.B2.Dz Jam in Right Door
Description
Media delay jam in top cover at image area.
Paper did not reach SR6 in specied time.
●
13.B2.D1
Media did not reach the Registration sensor in the designated amount of time printing from Tray 1.
●
13.B2.D2
Media did not reach the Registration sensor in the designated amount of time printing from Tray 2.
●
13.B2.D3
Media did not reach the Registration sensor in the designated amount of time printing from Tray 3.
●
13.B2.D4
Media did not reach the Registration sensor in the designated amount of time printing from Tray 4.
●
13.B2.DD
Media did not reach the Registration sensor in the designated amount of time printing duplexed.
Recommended action
1. Open upper right door and check for media jammed in feed area.
282 Chapter 2 Solve problems ENWW