USB storage le system is full To clear touch “OK”
Description
The le system on the installed USB device is full.
Recommended action
Touch the OK button to clear this error.
Used supply installed To continue, touch “OK” OR Used supply in use Description
Description
The toner cartridges or supplies has been previously used.
Recommended action
If you believe you purchased a genuine HP supply, go to www.hp.com/go/anticounterfeit.
Verifying, Please Wait
Description
This message displays when the printer is retrieving a print job from device memory, but can cause the printer
control panel to lock up.
The user enter the Retrieve from Device Memory menu to print a job. After selecting the desired print jobs,
Verifying, Please Wait displays on the control panel. The status bar will move for a moment, and then lock
up. Typically, if the user waits a few minutes, the error will clear and the job will print.
In rare cases, the message will lock up permanently and force the user to power cycle the printer.
The event log might show the following errors as a result of power cycling the printer during lockup:
●
48.05.05
●
98.03.11
Recommended action
Turn the printer o and then on again.
Make sure the rmware is the latest revision.
Waiting for Tray <X> to lift
Description
The specied tray is in the process of lifting paper to the top of the tray (so it can feed correctly).
Recommended action
No action necessary.
388 Chapter 2 Solve problems ENWW
To Next Page
Loading...