HP LaserJet Enterprise M552 - USB needs too much power Remove USB and Then Turn Off then On; USB not initialized; USB storage accessory removed Clearing any associated data; USB storage device failure To clear touch “OK”

USB needs too much power Remove USB and Then Turn O then On
Description
A USB accessory is drawing too much electrical current. Printing cannot continue.
Recommended action
1. Turn the printer o.
2. Remove the USB accessory.
3. Turn the printer on.
4. Try a similar USB accessory that has its own power supply or requires less power.
USB not initialized
Description
The le system on the USB device must be initialized before it can be used.
Recommended action
Use the HP Embedded Web Server or HP Web Jetadmin to initialize the USB device.
USB storage accessory removed Clearing any associated data
Description
This message displays for about 6 seconds after a USB device is removed.
Recommended action
Touch the Hide button to remove this message.
USB storage device failure To clear touch “OK”
Description
The specied device failed.
Recommended action
Touch the OK button to clear this error.
USB storage le operation failed To clear touch “OK”
Description
A PJL le system command was received that attempted to perform an invalid operation, such as
downloading a le to a nonexistent directory.
Recommended action
Touch the OK button to clear this error.
ENWW Tools for troubleshooting 387