HP LaserJet Enterprise M552 - Network connection; Connect a remote connection

3. In the Windows Features box, scroll down to Telnet Client. If the check box is not checked, click the box
to select it, and then click the OK button.
TIP: If the check box is already checked then the telnet client function is already enabled. Click the
Cancel button.
Figure 2-6 Enable the telnet client feature
Network connection
The remote telnet client computer must have direct network access to the printer for the Remote Admin
function to operate. This means that the telnet client computer must be on the same network as the printer.
The Remote Admin function cannot be accessed through a network rewall or other remote access network
security programs.
If a private network is not accessible, ask the network administrator to set up a virtual private network (VPN)
connection to the network.
Connect a remote connection
Start the telnet server function at the printer
For security reasons the Remote Admin feature must be initiated by a person that is physically present at the
printer. The following steps must be performed by a person that is physically present at the printer.
NOTE: This person might need to sign in with an administrator or service password depending on how the
printer is congured.
1. Turn the printer on.
2. The HP logo displays on the printer control panel. When a 1/8 displays below the logo, touch in the
middle of the control-panel display to open the Pre-boot menu.
100 Chapter 2 Solve problems ENWW