The fuser has been removed or installed incorrectly.
Recommended action
WARNING! The fuser can be hot while the printer is in use. Turn the printer o, and then wait for the fuser to
cool before handling it.
1. Remove the output bin or stapler/stacker.
2. Remove the fuser entrance guide.
3. Remove the fuser then reinstall it.
4. IF message remains, replace the fuser.
Replace or reinstall the print cartridge correctly to continue printing.
Install Supplies
Description
More than one supply is missing or is installed incorrectly.
●
10.00.15 (event code): Black print cartridge
●
10.23.15 (event code): Fuser kit
Recommended action
Touch the OK button to identify which supplies need to be replaced.
Touch the OK button a second time for more information about the specic supply.
Insert the supply item or make sure the installed supply item is fully seated.
Internal disk device failure To clear touch “OK”
Description
82.0X.YY (event code)
The internal disk failed.
Recommended action
1. Touch the OK button to clear the error.
2. If the error persists, turn o the printer, and then remove and reinstall the hard drive.
3. Turn on the printer.
4. If the error persists, replace the internal hard drive.
Internal disk le operation failed
Description
A PJL system command attempted to perform an invalid operation, such as downloading a le to a
nonexistent directory.
ENWW Tools for troubleshooting 369
To Next Page
Loading...