Recommended action
1. Turn the product o, and then on again.
2. Resend the print job.
3. If the error persists, clear the active partition by using the Partial Clean item in the Preboot menu.
47.WX.YZ Printer Calibration Failed To continue, touch “OK”
Description
The device is unable to access or implement one of the image patterns les.
Y = Calibration type, Z = Event
●
47.FC.00 (event code) Color plane registration (CPR) Image not found at system initialization
●
47.FC.01 (event code) CPR Store Image failure
●
47.FC.02 (event code) CPR Image not found
●
47.FC.03 (event code) CPR Print engine execution failure
●
47.FC.10 (event code) Consecutive Dmax Dhalf Image not found at system initialization
●
47.FC.11 (event code) Consecutive Dmax Dhalf Store image failure
●
47.FC.12 (event code) Consecutive Dmax Dhalf Image not found
●
47.FC.13 (event code) Consecutive Dmax Dhalf Print engine execution failure
●
47.FC.20 (event code) Error Diusion Image not found at system initialization
●
47.FC.21 (event code) Error Diusion Store image failure
●
47.FC.22 (event code) Error Diusion Image not found
●
47.FC.23 Error Diusion Print engine execution failure
●
47.FC.30 0 (event code) Drum Speed Adjustment Image not found at system initialization
●
47.FC.31 (event code) Drum Speed Adjustment Store image failure
●
47.FC.32 (event code) Drum Speed Adjustment Image not found
●
47.FC.33 (event code) Drum Speed Adjustment Print engine execution failure
●
47.FC.40 (event code) Pulse Width Modulation Image not found at system initialization
●
47.FC.41 (event code) Pulse Width Modulation Store image failure
●
47.FC.42 (event code) Pulse Width Modulation Image not found
●
47.FC.43 (event code) Pulse Width Modulation Print engine execution failure
Recommended action
1. Turn the product o, and then on again.
2. If the error persists over multiple power cycles frequently and consistently on a unit then do the
following.
330 Chapter 2 Solve problems ENWW
To Next Page
Loading...