Table 2-53 Print modes under the Optimize submenu (continued)
Heavy Paper Set to Smooth when printing on smooth, heavy media types.
Envelope Control Set to Reduced Temp if envelopes are sticking due to moisture in
the envelop adhesive.
Tray 1 Set the mode to Alternate if marks appear on the back side of the
paper when printing from Tray 1. This sets the printer to initiate a
clean sequence every time a job nishes when the printer is set
for Any Size and Any Type for Tray 1.
Background Set to Alternate 1 when a background occurs all over the page.
Uniformity Control Set to Alternate 1 to improve uniformity on any paper type.
Tracking Control Improves color stability by adjusting the bias voltage. Make sure
this mode is set to On.
Registration Set to Alternate when color misregistration occurs.
Transfer control Set to Alternate 1 to reduce primary transfer bias and to resolve
low density or blotchy images.
Restore Optimize Use Restore Optimize to reset the menu defaults.
408 Chapter 2 Solve problems ENWW
To Next Page
Loading...