4. Make sure that the roller assembly is correctly installed. It must not hang down into the tray cavity. If
the roller hangs down into the tray cavity, remove it, and then reinstall it.
CAUTION: If the roller assembly is not correctly installed, it will be damaged when the tray is installed.
Figure 2-135 Verify the roller installation
5
. Close the right door.
With the front of the tray slightly lifted, align the sides of the tray with the rails in the printer, and then
carefully slide the tray into the printer.
TIP: As the tray slides into the printer, lower the front of it.
Figure 2-136 Install the tray
438 Chapter 2 Solve problems ENWW
To Next Page
Loading...