First level Second level Value Description
Clear Event Log Clear Use this item to clear the printer
event log.
Cycle Counts Total Engine Cycles Set the page count that was
stored in NVRAM prior to
installing a new formatter.
Mono Cycle Count Set the mono page printed
count.
Color Cycle Count Set the color page printed count.
Refurbish Cycle Count Use this item to record the page
count when the printer was
refurbished.
Serial Number Set the serial number.
Service ID Use this item to show the date
that the printer was rst used on
the control panel. This
eliminates the need for users to
keep paper receipts for proof of
warranty.
Cold Reset Paper When you perform a cold reset,
the paper size that is stored in
NVRAM is reset to the default
factory setting. If you replace a
formatter board in a country/
region that uses A4 as the
standard paper size, use this
menu to reset the default paper
size to A4. LETTER and A4 are
the only available values.
New Registration Roller Yes
No
Reset the counter for the
registration roller after replacing
the registration assembly.
New Transfer Kit Yes
No
Reset the counter for the
registration roller after replacing
the transfer kit.
Low Alerts Enable
Disable
Turn on (or o) low alerts (for
supplies).
Reset Low Alerts
●
Reset to level 1
●
Reset to level 2
●
Reset to level 3
●
Set to non-HP managed
mode
Test Support Continuous Print from USB
Automatic Calibrations Disabled
Enabled*
478 Chapter 2 Solve problems ENWW
To Next Page
Loading...