JUNOS Internet Software Network Operations Guide: Hardware
138 ! Monitoring the Routing Engine Status
Alternative Actions (For M7i, M10i, M40e, M160, M320, and T320 routers and the T640 routing node)
To check the status and temperature of the Routing Engines, use the following CLI
command:
user@host> show chassis environment routing-engine
user@host>
show chassis environment routing-engine
Route engine 0 status:
State: Present Master
Temperature: 0 degrees C / 32 degrees F
Route engine 1 status:
State: Present
The command output displays the Routing Engine slot number, operating state,
temperature, and whether it is operating as the master or backup. The state can be
Present or Absent.
To check the status and temperature of a particular Routing Engine, use the
following CLI command:
user@host> show chassis environment routing-engine slot
Step 2: Check the Routing Engine LEDs
Steps To Take To check the Routing Engine status LEDs, do one of the following:
1. Check the M7i Routing Engine LEDs on page 139
2. Check the M10i Router Routing Engine LEDs on page 139
3. Check the M20 Router Routing Engine LEDs on page 140
4. Check the M40 Router Routing Engine LEDs on page 142
5. Check the M40e and M160 Router Routing Engine LEDs on page 143
6. Check the M320 Router Routing Engine LEDs on page 144
7. Check the T320 Router Routing Engine LEDs on page 144
8. Check the T640 Routing Node Routing Engine LEDs on page 145
To Next Page
Loading...
Need help?
General
