JUNOS Internet Software Network Operations Guide: Hardware
476 ! Determining Which Routing Engine You Are Logged In To
Step 1: Display Routing Engine Status
Action To determine which Routing Engine you are logged in to, use the following CLI
command:
user@host> show chassis routing-engine
Sample Output
user@host>
show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Election priority Master (default)
Temperature 29 degrees C / 84 degrees F
DRAM 2048 MB
Memory utilization 11 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 2 percent
Interrupt 0 percent
Idle 98 percent
Model RE-3.0
Serial ID P10865701859
Start time 2004-04-15 18:45:12 UTC
Uptime 6 days, 3 hours, 56 minutes, 8 seconds
Routing Engine status:
Slot 1:
Current state Backup
Election priority Backup (default)
Temperature 26 degrees C / 78 degrees F
DRAM 2048 MB
Memory utilization 10 percent
CPU utilization:
[...Output truncated...]
What It Means The output from the show chassis hardware command indicates that you are logged
in to the master Routing Engine because this command can only be used on the
master Routing Engine.
If you are not logged in to the master Routing Engine, you will see the following
command output:
user@host> show chassis hardware
error: Aborted! This command can only be used on the master routing engine.
To Next Page
Need help?
General
