EasyManuals Logo
Home>Juniper>Software>JUNOS - NETWORK OPERATION GUIDE REV1

Juniper JUNOS - NETWORK OPERATION GUIDE REV1 User Manual

Juniper JUNOS - NETWORK OPERATION GUIDE REV1
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #671 background imageLoading...
Page #671 background image
CLI Operational Mode ! 635
Appendix A: Command-Line Interface Overview
Using the CLI Operational Mode
This section describes how to use the CLI operational mode. You can do the
following:
! Entering the CLI Operational Mode on page 636
! Getting Help on Commands at a Hierarchy Level on page 636
! Getting Help About Commands on page 636
! Having the CLI Complete Commands on page 638
! Using CLI Command Completion on page 638
! Displaying CLI Command History on page 639
show Show information about all aspects of the software, including interfaces
and routing protocols.
Syntax:
show <accounting | aps | arp | as-path | bgp | chassis |
class-of-service | cli | configuration | connections | dvmrp | firewall | helper |
host | igmp | ike | ilmi | interfaces | ipsec | ipv6 | isis | l2circuit | l2vpn | ldp |
link-management | log | mpls | msdp | multicast | ntp | ospf | ospf3 | passive
monitoring | pfe | pim | policer | policy | rip | ripng | route | rsvp | sap |
services | snmp | system | task | ted | version | vrrp>
ssh
Open a secure shell to another host.
Syntax:
ssh host-name <bypass-routing> <interface interface-name> <inet
| inet6> <routing instance routing-instance-name> <source source-name>
<v1 | v2> <vpn-interface vpn-interface-name>
start
Start a software process.
Syntax:
start shell
telnet
Start a telnet session to another host.
Syntax:
telnet host-name <8bit> <bypass-routing> < inet | inet6>
<interface interface-name> <logical-router logical-router-name>
<noresolve> <port port-number> <routing-instance routing-instance-name>
<source source-address>
test
Run various diagnostic debugging commands.
Syntax:
test configuration (filename | terminal)
traceroute
Trace the route to a remote host.
Syntax:
traceroute host-name <as-number-lookup> <bypass-routing>
<gateway address> <inet><inet6> <logical-router logical-router-name>
<noresolve> <routing-instance routing-instance-name> <source address>
<tos value> <ttl value> <interface interface-name> <wait seconds>
Command Description

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper JUNOS - NETWORK OPERATION GUIDE REV1 and is the answer not in the manual?

Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Specifications

General IconGeneral
BrandJuniper
ModelJUNOS - NETWORK OPERATION GUIDE REV1
CategorySoftware
LanguageEnglish

Related product manuals