Getting CFEB Hardware Information ! 429
Chapter 32: Monitoring the CFEBs
7. Place one hand under the CFEB to support it, slide it completely out of the
chassis, and place it on the antistatic mat or in the electrostatic bag.
8. Verify that the ends of the ejector levers are pulled outward to a position nearly
perpendicular to the faceplate of the CFEB.
9. Place one hand under the CFEB to support it and grasp one of the ejector levers
at the front with the other hand.
10. Align the rear of the CFEB with the guides inside the chassis and slide it in
completely.
11. Press the ejector lever at each end of the CFEB inward.
Getting CFEB Hardware Information
Steps To Take To display CFEB hardware information, follow these steps:
1. Display the CFEB Hardware Information on page 429
2. Display the CFEB Firmware Information on page 430
3. Locate the CFEB Serial Number ID Label on page 430
Step 1: Display the CFEB Hardware Information
Action To display the CFEB hardware information, use the following CLI command:
user@host> show chassis hardware
Sample Output
user@host>
show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis 30512 M7i
Midplane REV 04 710-008761 CB9213 M7i Midplane
Power Supply 0 Rev 02 740-008985 QB12884 DC Power Supply
Routing Engine REV 09 740-009459 1000482742 RE-5.0
CFEB REV 04 750-010112 CB8664 Internet Processor II
FPC 0 E-FPC
FPC 1 E-FPC
PIC 2 BUILTIN BUILTIN 1x Tunnel
PIC 3 REV 04 750-009099 CB9103 1x G/E, 1000 BASE
What It Means The command output displays the CFEB version level, part number, serial number,
and description.
CAUTION: When a CFEB is out of the chassis, do not hold it by the ejector levers.
They cannot support the weight of the CFEB.
Do not stack CFEBs on top of or under other components. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat, stable
surface.
To Next Page
Loading...
Need help?
General
