Juniper JUNOS - NETWORK OPERATION GUIDE REV1 User Manual

Checking the Routing Engine Status ! 297
Chapter 21: Monitoring the Host Subsystem
Table 70 describes the T320 router and T640 routing node host subsystem LED
states.
Table 70: T320 Router and T640 Routing Node Host Subsystem Craft Interface LEDs
Checking the Routing Engine Status
This section provides a brief description of monitoring the Routing Engines as part
of the host subsystem on the T320 router and T640 routing node. For more detailed
information about monitoring the Routing Engine, see “Monitoring the Routing
Engine” on page 125.
Action To check the Routing Engine status, use the following CLI command:
user@host> show chassis routing-engine
Sample Output user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Election priority Master (default)
Temperature 28 degrees C / 82 degrees F
CPU temperature 27 degrees C / 80 degrees F
DRAM 2048 MB
Memory utilization 11 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 5 percent
Interrupt 1 percent
Idle 94 percent
Model RE-4.0
Serial ID P11123900322
Start time 2004-09-25 19:32:31 PDT
Uptime 9 days, 20 hours, 53 minutes, 8 seconds
Load averages: 1 minute 5 minute 15 minute
0.00 0.00 0.00
Routing Engine status:
Slot 1:
Current state Backup
Election priority Backup (default)
Temperature 29 degrees C / 84 degrees F
CPU temperature 30 degrees C / 86 degrees F
DRAM 2048 MB
Memory utilization 10 percent
CPU utilization:
[...Output truncated...]
Label Color State Description
OK Green On steadily Host is online and functioning
normally.
FAIL Red On steadily Host is offline.
MASTER Green On steadily Host is functioning as master.

Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Specifications

General

Brand	Juniper
Model	JUNOS - NETWORK OPERATION GUIDE REV1
Category	Software
Language	English