Juniper JUNOS - NETWORK OPERATION GUIDE REV1 User Manual

JUNOS Internet Software Network Operations Guide: Hardware
438 ! Performing A Swap Test
Kernel 0 percent
Interrupt 0 percent
Idle 100 percent
Model RE-3.0
Serial ID P10865703096
Start time 2005-02-16 22:13:19 UTC
Uptime 2 hours, 13 minutes, 57 seconds
Routing Engine status:
Slot 1:
Current state Master
Election priority Backup (default)
Temperature 33 degrees C / 91 degrees F
CPU temperature 29 degrees C / 84 degrees F
DRAM 2048 MB
Memory utilization 12 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 3 percent
Interrupt 0 percent
Idle 97 percent
Model RE-3.0
Serial ID P10865701255
Start time 2005-02-03 03:13:39 UTC
Uptime 13 days, 21 hours, 12 minutes, 35 seconds
Load averages: 1 minute 5 minute 15 minute
0.00 0.03 0.01
What It Means The HCM in the slot labeled HCM0 is paired with the Routing Engine in the slot
labeled
RE0. Likewise, the HCM in the slot labeled HCM1 is paired with the Routing
Engine in the slot labeled
RE1. By default, the HCM in the slot labeled HCM0 is the
master. However, in this instance, the Routing Engine in slot
RE1 has taken over
mastership, indicating that the HCM in slot
HCM1 is also master.
Performing A Swap Test
The HCM is hot-pluggable. You can perform a swap test on an HCM to pinpoint the
problem.
NOTE: although steps to remove and install an HCM are provided here, ensure that
you refer to the appropriate hardware guide for the latest information.
Before performing a swap test, always check for bent pins in the midplane and
check the HCM for stuck pins in the connector. Pins stuck in the component
connector can damage other good slots during a swap test.

Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Specifications

General

Brand	Juniper
Model	JUNOS - NETWORK OPERATION GUIDE REV1
Category	Software
Language	English