JUNOS Internet Software Network Operations Guide: Hardware
648 ! CLI Configuration Mode
Displaying the Configuration at the Current Hierarchy Level
To display the configuration at the current hierarchy level or at the specified level,
use the
show configuration mode command.
user@host> show <statement-path>
The configuration statements appear in a fixed order. The CLI indents each level in
the hierarchy to indicate each statement’s relative position in the hierarchy and
generally sets off each level with braces, using an open brace at the beginning of
each hierarchy level and a closing brace at the end. If the statement at a hierarchy
level is empty, the braces are not printed. Each leaf statement ends with a
semicolon. If the hierarchy does not extend as far as a leaf statement, the last
statement in the hierarchy ends with a semicolon. Interfaces appear alphabetically
by type, and then in numerical order by slot number, PIC number, and port number.
Displaying the Last Committed Current Configuration
You also can use the CLI operational mode
show configuration command to display
the last committed current configuration, which is the configuration currently
running on the router:
user@host> show configuration
Displaying Users Currently Editing the Configuration
To display the users currently editing the configuration, use the
status configuration
mode
command:
[edit]
user@host# status
Current configuration users:
user terminal p0 (pid 518) on since 2002-03-12 18:24:27 PST
[edit protocols]
The system displays who is editing the configuration (user), how the user is logged
in (
terminal p0), the date and time the user logged in (2002-03-12 18:24:27 PST),
and what level of the hierarchy the user is editing (
[edit protocols]).
To Next Page
Need help?
General
