Mitsubishi Electric Q12DCCPU-V - Connection between C Controller Module and GOT; Microcomputer Connection of GOT

4 - 47
4.14 Connection Between C Controller Module and GOT (Microcomputer Connection)
4
FUNCTIONS
4.14 Connection Between C Controller Module and GOT
(Microcomputer Connection)
(1) Connection between the C Controller module and GOT (Microcomputer
connection)
By connecting an RS-232 cable from a GOT to the C Controller module's RS-232
interface, the C Controller module can communicate with the GOT using virtual
devices inside the GOT.
For this communication, create a user program referring to a sample program
included in SW3PVC-CCPU.
Remark
1. For the sample program, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
2. For the microcomputer connection of GOT and available communication
commands, refer to the following.
Manual for the GOT
Figure 4.22 Microcomputer connection of GOT
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
C Controller module
D0
D100
D4095
D163
000A
0362
D0 to 4095
Virtual devices inside GOT
Interrupt output
Write/Read command
S
T
X
RW 0100 000A 0163 0362
E
T
X
D3