Mitsubishi Electric Q12DCCPU-V - I;O Number Assignment; Number of Base Units and Number of Slots

7 - 1
7.1 Number of Base Units and Number of Slots
7
I/O NUMBER ASSIGNMENT
CHAPTER 7 I/O NUMBER ASSIGNMENT
This chapter explains the I/O number assignment that is required for data communications
between the C Controller module and I/O modules and intelligent function modules.
7.1 Number of Base Units and Number of Slots
The C Controller module can be used in the following system configurations.
• One main base unit and extension base unit(s)
• One slim type main base unit
(1) Available configuration and number of slots
For details, refer to t he following.
Page 2-9, Section 2.1.4
POINT
The number of available slots (modules) includes empty slots.
(Even if Slot 2 is set to "Empty, 0 point" as shown below, it is occupied as one
slot.)
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Q12DCCPU-V Q06CCPU-V Q06CCPU-V-B
Occupies 1 slot.
0CPU 1 3 42
Points per slot 16 16 16 160
Input OutputEmptyInputInput